Mustek PP3000 Manual do Utilizador descarregar pdf (Página 28)

3 - 8

PST-7000 series user’s manual – BRIEF INTRODUCTION

CUSTOMER DISPLAY

When the PST7000 series is ordered with the customer display option, the

terminal will be delivered with the base tube for the display already fitted to corner of

the display platform.

The customer display head can be easily inserted into the base tube after first

inserting the signal cable. The release button on the base tube must be pulled out to

allow the inner tube of the display head to travel down into the base tube (ref. Fig. 3-

5). Please ensure that the latching track on the inner-pole matches up with the release

button. Open the back door and find the connector marked “customer display” or

“VFD”. Please remove the VFD terminator from this connector and store in a safe

place. Insert the cable plug of the customer display into customer display connector

until a click sound is heard.

Please NOTE: The VFD connector must always be populated either with

the VFD terminator or a plug from the customer display (Failure to do this will

prevent COM1 from working correctly).

Close the back door then slide the two door latches outward and the

installation is completed. Please refer to the instructions in the part “TO USE THE

PST SYSTEM” for later adjustment on the most comfortable position and direction of

the customer display.

Fig. 3 - 5 Customer display installation

BASE TUBE

RELEASE

BUTTON

INNER

POLE

CABLE

GOES IN

FIRST

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 66 67

Sem comentários

Mustek PP3000 Manual do Utilizador Página 28