Mustek PP3000 Manual do Utilizador descarregar pdf (Página 37)

3 - 17

PST-7000 series user’s manual – INSTALLATION GUIDES

PRINTER

Assemble the printer following the instructions supplied with the printer.

Remove the battery cover first by pressing down at one end (ref. Fig. 3-13)

and pushing out the battery cover as shown. The user may find the UPS battery lying

in the battery compartment if this option is ordered. Connect the cable through the

opening on the wall toward the rear room of the cabinet to the connector marked

“LPT 1” (if the printer is a parallel printer as ref. Fig. 3-14). Or connect the cable to a

proper “COM” port (COM 1 through COM 4) according to the definition on the

application program (if the printer is a serial printer). The 24 VDC power cable should

be attached to the 24 VDC connector in the rear compartment if the printer is to use

this power supply from the terminal. These cables should be passed through “opening

A” as shown in fig 3-13. The battery compartment cover should now be replaced and

the signal and power cables should be attached to the appropriate connectors on the

underside of the printer. Finally the printer should be placed into position on the

printer platform of the terminal. The Velcro strips in the accessories kit may be used

to firmly anchor the printer into position.

L1L1

L0L0

LPLP

L2L2

L3L3

L4L4

Fig. 3 - 13 Removal of battery cover

PRINTER

PLATFORM

DISPLAY

PLATFORM

OPENING TO

REAR ROOM

BATTERY

COVER

PRESS THIS END

DOWN AND

PUSH THIS

WAY TO OPEN

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 66 67

Sem comentários

Mustek PP3000 Manual do Utilizador Página 37