Mustek PP3000 Especificações descarregar pdf (Página 48)

PST-1000 series Technical Manual 5 - 20

PROGRAMMABLE KEYBOARD

HOT KEY PROGRAMMING

The POSIFLEX programmable keyboard supports the “Hot key programming”

method which is most useful in instant modification of a few keys in a

preprogrammed keyboard without entering the more sophisticated programming

utility. Of course, the user may also use this feature to program through out all 112

keys by 5 pages (LP and L1 to L4) at will. The whole process of “Hot key

programming” contains 4 steps for each key to be programmed and is illustrated as

following:

PREPARATION

Please connect a standard PC or PS-2 keyboard to the external keyboard port

and settle the software and the rest hardware exactly the way application program

requires before entering “Hot key programming” mode. The user shall then decide

which key of which page is to be programmed and turn the 6 position control key to

the proper position before entering the “Hot key programming” mode. Please note that

the answer back codes of the position control key is not covered by the “Hot key

programming” feature.

ENTER “HOT KEY PROGRAMMING” MODE

To enter the “Hot key programming” mode, the user must input the “Hot key”

and identify the key on the programmable keyboard to be programmed. The so called

“Hot key” is a special combination of keys pressed on the standard PC or PS-2

keyboard. In PST programmable keyboard, the “Hot key” is defined as pressing and

holding the left “Alt” key while pressing the “PRT SC” (“Print Screen”) key on the

PC or PS-2 keyboard. And by doing so, the programmable keyboard will give 2 beeps

to notify that it is ready to receive the identification of which key to be programmed.

Preparation

Enter “hot key

programming”

mode

Input the

content to be

programmed

Exit “hot key

programming”

mode

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 78 79

Sem comentários

Mustek PP3000 Especificações Página 48